3D prints enhanced!

Recently I’ve been playing around with different materials that could make even cheap, weak 3D prints into solid and beautifull sculptures. With the help of my firend, I’ve got my print sprayed with a solution that is originaly made for protection of boats from water. It made it more sturdy, bendable and a whole lot premium looking!

Object was originaly 3mm thick and printed with usual PLA – not very bendable. Now the protection layer is only 2 mm thick and look how much more bendable it is! Now it is also resistant to scratches and water.

 

Check out our results:

 

 

 

 

 

Share on FacebookShare on LinkedInTweet about this on TwitterEmail this to someone

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *